Category: Geek
Updating Optiboot & CC3000 Firmware with an Arduino
I recently purchased a CC3000 wireless board to play with on Arduinos, with an aim to use it on an Arduino Mini Pro to control some LED lighting I have. Rather than purchasing through Adafruit as I possibly should have done, it was ordered through Ebay. This turned it into a bit […]
Read MoreGitlab Setup and Timeouts
So I wanted a place to store all my private Git repositories, without going down the paid route that is Github. Callum had just set up Gitlab at work, so I thought it might be wise to just use the same toolset. What with it being installed on a VM […]
Read MoreThinkpad X201S Fan Control
I noticed the other day (it was kind of hard to not notice, to be honest) that my laptop shut down abruptly when it overheated. This shouldn’t be the case, as the thermal controls on the mainboard should have spun up the fans. After some poking around, I found that […]
Read MoreOWFS Server on The Raspberry Pi
Quick and simple this one is. I have a DS9490R (internally it’s a DS1490F) one-wire bus master attached to my Raspberry Pi. 4 DS18B20 temperature sensors are hanging off the bus, and I’d like to access them from the home automation server. On the Raspberry Pi, or the server/device that’s […]
Read MoreMQTT GPIO Monitoring
My little Raspberry Pi seems to be growing arms and legs. The other day I hooked up a simple PIR to it. I can’t remember where I got it, but it runs off 5v, consumes a low enough amount of milliAmps to be directly connected to the Raspberry Pi 5v […]
Read More
Recent Comments